What is this about?
Mobile equipment fires occur regularly in the mining industry and present a significant fatality risk and are potentially catastrophic for underground operations. They also involve considerable costs for mining operators.
This industry project considering improvements in these areas:
- OEM equipment design e.g. separation of flammable liquid systems from heat sources.
- Routine maintenance practices including hot work.
- Coordination of fire detection and suppression systems design and installation between OEM and third-party suppliers.
- Maintenance of fire suppression systems after installation noting that this can be a challenging issue for remote operations.
Is the issue relevant to us?
If your operations use mobile equipment and you are committed to maintaining and improving the reliability of fire prevention and mitigation controls, then this resource can assist you.
The regulator position information provides an overview of industry level performance and should be considered when reviewing your own operations.
Code of Practice Emergency management for Western Australian mines
Emergency management for Western Australian mines, code of practice providing guidance on fire response requirements [More...]
Diesel engine – turbocharger fires
Incident report on a fire on a Turbocharger - with recommendations to prevent incident recurrence [More...]
Equipment fires, investigation and response
A report highlighting concerns regarding equipment fires on mobile equipment on mine sites [More...]
Fire and explosion risks on hydraulic excavators
Hydraulic excavators involved in fires leads to recommendations to prevent recurrence and provides guidance on leading practice. [More...]
Fire on a personnel transport vehicle
Air compressor delivery hose as a cause of a file on a personnel transport vehicle [More...]
Fire on an underground loader
Lessons learned from a fire on a loader in the hazardous zone of a coal mine [More...]
Fire on diesel electric truck
Truck fire arising from a fuel leak could not be extinguished [More...]
Fires on mine sites
Results of a statistical analysis into fires on mine sites [More...]
Mobile equipment contact with high-voltage overhead power lines Mines Safety Bulletin No. 85
High-voltage overhead power lines can lead to vehicle fires [More...]
MSHA Alert 14 May 2019
A fire occurred on a modified item of U/G plant in a USA coal mine. There was no detection of the heat build up and a subsequent failure of the fire suppression system led to a more significant incident occurring that would otherwise have happened. The regulator identified 7 key safety practices that should be included [more...]
MSHA Bear Run Fatality – Haul Truck Fire
A fatality arose due to a failure of access stairs to a truck cabin when a fire occurred [More...]
NSW Australia Dangerous Incident Notification 0036553 – Fire on Dump Truck
Fire on a dump truck identified a range of potential operational and equipment improvements [More...]
NSW Australia Initial Report of Dangerous incident Notice 0036106 – Electrical Fire on Truck
Fire on a haul truck arising from a modification to the electrics of the control panel...[More]
NSW Dangerous incident Notice 0036106 – Electrical Fire on Truck
Incident notification regarding an electrical fault with recommendations [More...]
Preventing Fires on Mobile Plant
Discussion paper on options for preventing fires on mobile plant [More...]
Rear hub failure and subsequent fire
Queensland Government, Australia, Safety Bulletin from February 2004. The rear hub of a dual set of wheels on a rear dump truck cracked around the circumference and parted. This wheel hub/rim failure cut through a brake line and initiated a fire [More...]
Overheated tyres cause a smoke event in an underground mine - improvements are identified to prevent recurrence [More...]
Investigation findings and recommendations from an excavator fire (which was a complete loss) [More...]
Incident analysis and recommendations related to a truck fire [More...]
Agitator truck, underground metals mine, Cobar, mon-metallic engine covers and guards, fuel load, fuel tank puncture [More...]
Analysis and recommendations following a major excavator fire [More...]
Analysis and recommendations following an incident investigation into a truck fire where the driver was trapped in the cabin by flames [More...]
A design feature in light vehicles makes potential for fire worse [More...]
Incidents related to fuelling fires are analysed [More...]
Battery fires and incidents are analysed and recommendation made [More...]
Fires related to the working environment are analysed for drilling rigs [More...]
Underground mobile equipment fires
Potential hazards when underground equipment catches fire [More...]
WA MSH_SB_010 Light Vehicle Fire EDIC removed
Within a two month period two underground fires on Toyota 4 x 4 Land Cruisers were reported. [More...]
WA MSH_SB_090 Total Fires Ban
Practical application to mining operations when total fire bans are declared [More...]
WA MSH_SIR_015 Powerline contact
Whilst moving away from a stockpile, the raised tray of a haul truck severed a 33,000 V overhead power line. The driver proceeded unaware [More...]
Western Australia Government Safety Bulletin 100 – Flammable Airconditioning Gas
A hydrocarbon refrigerant may reduce some hazards but fire hazards may be increased. [More...]
Western Australia Significant Incident Report 147 Salt harvester fire no emergency egress
Fire and entrapment hazard on mobile plant (salt harvester) - absence of a second egress [More...]
Western Australia Significant Incident Report 181 Hydraulic Hose failure on Dump Truck
A dump truck operating at an open pit mine caught fire when a hose-end fitting separated on a singlewire reinforced hydraulic hose. Oil sprayed onto hot engine components [More...]